DKS 1803PC Owner's Manual Page 30

  • Download
  • Add to my manuals
  • Print
  • Page
    / 39
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 29
3.5 Block Diagram Single Door – Typical
The block diagram below shows the necessary wire runs needed when all options (gate
operator data, alarm outputs, door and reset switches, request to exit, etc.) available with the
2351 Tracker board are utilized.
GATE
OPER 1
5
GATE
OPER 2
5
CARD
READER
4
6
TO
CONTROLLER
AND OTHER
BOARDS
LOCAL
ALARM
2
ALARM
SYSTEM
2
BOARD
POWER
2
4
EXIT
SWITCH
2
2
DOOR
SWITCH
RESET
SWITCH
2
GATE OR
DOOR
2
LOCK
POWER
2
Block Diagram - 2351-010
Expansion Board
2351-010
Card Reader is wired using Belden 9418 or equivalent. If card reader is
lighted, two additional conductors are required for light power.
Card Reader can be substituted with most devices that output data in 26-bit
weigand format.
Power supply uses minimum 18 GA. Wire.
Ground circuit board. Use 12 GA. Wire.
Gate operator inputs are for operator data only.
Gate operator input 1 from DKS slide, swing or overhead operators only.
Gate operator input 2 from DKS barrier gate operators only.
Local alarm and alarm system outputs are dry relay contacts.
NOTES:
1 common conductor
to all three switches.
1
DOORKING, INC., INGLEWOOD, CA 90301
Title:
Date: Rev.Dwg. No.4/02
A
M2351-065-10
BLOCK DIAGRAM - 2351 BOARD
Light Power
2
30
Page view 29
1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 38 39

Comments to this Manuals

No comments