DKS 1601 Installation Guide download pdf (Page 25)

1601-065-M-05-07

26 installation guide

settings/direction check

SW1 SW2

POWER

OFF

AUTO

DOWN

&,)0-!'.%43

SW1 SW2

POWER

OFF

AUTO

DOWN

Before installing the barrier arm the rotation of the output shaft must be checked. The rotation of the arm is dependent on how

the operator has been installed (door of the operator opposite the traffic lane, or door of the operator facing the traffic lane), and

if the operator has been installed on the left or right hand side of the traffic lane. It is important that the shaft rotation be checked

BEFORE installing the arm(s) onto the operator.

NOTE: If the output shaft rotation is in the opposite di-

rection for your application and the arm(s) has been

installed prior to checking the rotation direction, dam-

age to both the arm(s) and the operator may result

when the operator is placed in service.

Turn ON the barrier operator and place the control toggle

switch to the UP position and check the shaft rotation;

continue to step 2 if rotation is incorrect.

Turn the operator power OFF at the breaker

panel.

Remove the plastic circuit board cover.

Loosen the magnet nut; each magnet has a

marking on one side.

Reinstall the plastic circuit board cover and

repeat step 1 to check rotation.

Check the magnet and flip to the

opposite side.

Manually turn the drive pulley to ac-

cess the other magnet.

Check the magnet and flip to the

opposite side.

One magnet must have the marking

facing out and one magnet must have

the marking facing in.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 35 36

No comments

DKS 1601 Installation Guide Page 25