DKS 1601 Installation Guide download pdf (Page 30)

1601-065-M-05-07

installation guide 31

accessory installation/heater kit

To avoid the gearbox oil from freezing an optional heater kit is recommended in areas where temperatures routinely

drop below 40°F (4°C).

SWITCH SETTING

OFF - Turns the heater off.

ON - Turns the heater on continuously. Use

with caution since the heater can become

very hot when running continuously.

AUTO - Normal setting. The heater will

automatically turn on when the tem-

perature inside the cabinet falls below

40°F, and will turn off when the tem-

perature rises above 40°F.

Turn the operator power OFF at the circuit breaker panel; all connections will be made to

the high voltage terminal strip.

Install the heater on the right side of cabinet using the pre-existing mounting screws screws. NOTE: Place #10 washers on the

mounting screws before placing the heater assembly on the screws. Place #10 between the cabinet and the heater assembly.

Route the wiring through the side of the access door as shown. Use the supplied hardware to secure

the wire assembly. Be sure that the wire assembly is clear of all moving parts.

Connect the BLACK wire to the 117 VAC terminal on the high voltage terminal block. Connect the

WHITE wire to the NEUT terminal.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36

No comments

DKS 1601 Installation Guide Page 30