DKS 1601 Installation Guide download pdf (Page 28)

1601-065-M-05-07

installation guide 29

accessory installation/reversing edge

.06/5*/($)"//&-

3&7&34*/(&%(&

Turn operator power OFF and center and secure the 6-foot mounting channel

to the bottom of the barrier arm using ¾-inch wood screws (not supplied).

In addition to the electronic reversing device (ERD) an optional electric reversing edge (p/n 8080-016) maybe installed of-

fering additional protection to the arm, operator and obstruction.

Slide the reversing edge into the mounting channel

as shown.

Drill a ¼-inch hole on the side of the operator cabinet beneath the operator shaft

and install a grommet to protect the lead-in wire from any sharp metal edges.

Using wire ties (not supplied) secure the lead-in wire along the side of the

arm; leave a loop allowing the arm to rotate without obstruction.

Route the lead-in wire through the hole and connect to terminals 9

and 14 without interfering with any moving parts.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34 35 36

No comments

DKS 1601 Installation Guide Page 28