DKS 1601 Installation Guide download pdf (Page 23)

1601-065-M-05-07

24 installation guide

settings/control board

Settings and adjustments should be made after installation and wiring to the operator(s) is complete. Power must be shut-off before

programming switches on the circuit board are changed and turned back on for the new setting to take effect.

SW1 SW2

1. DIP SWITCHES - Turn OFF/ON operating

features and modes.

2. AUTO CLOSE TIMER - Adjust from one (1)

second to (when set to full counter clock-wise)

to approxamately 60 seconds (when set to full

clock-wise).

3. RELAY 1 CONTACT - (terminals 12-13)

can be set for Normally Open (NO) or Normally

Closed (NC) operation by placing the relay

shorting bar on the NO or NC pins respectively.

Relay activation is dependant on setting of

SW1, switch 5.

4. ARM RELAY CONTACTS - (C – NC – NO)

This relay can be used for a variety of purposes

and is typically used to signal when the arm is

up or down.

5. POWER LED - Indicates that low voltage

power is applied to the circuit board. The input

LEDs should be OFF and will only illuminate

when the input is activated.

6. LIMIT LED - On when the arm is in the

respective position.

7. TRACKER ACTIVITY LED - See page 14.

An automatic sensor system that senses entrap-

ment of a solid object and is incorporated as a

permanent and integral part of the operator.

8. GATE OPERATOR DATA TERMINAL

- Operator status reporting; cycle count, shorted

inputs, loop detector problems, power interrup-

tions, etc.

DIP

SWITCHES

AUTO CLOSE

TIMER

ARM RELAY

CONTACTS

RELAY 1

CONTACT

POWER

LED

LIMIT LED

TRACKER ACTIVITY LED

GATE OPERATOR

DATA TERMINAL

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 35 36

Comments to this Manuals

No comments

DKS 1601 Installation Guide Page 23

Comments to this Manuals

Related products and manuals for Gate Opener DKS 1601